Introduction of Bute-PE Coiled Pipes

Coiling of Bute-PE pipes by using a winder specially designed and fabricated according to the requirements set by Buteline MY with technical inputs provided by Ditron Tool & Die Ltd. (Buteline’s in-house R & D Centre)

August 2007

After spending years in conducting feasibility study and technical evaluations, we have finally rolled out our Bute-PE pipes in coiled form and released it into the local marketplace in early August, 2007. How was the response? Fantastic! We were compelled to run our pipes production 24 hours a day, non-stop with no exception during the weekends.

By using a custom made pipe winder fabricated to our own specifications, Buteline MY is capable of producing Bute-PE pipes with close dimensional tolerances. These pipes, which come in 50 meter/roll, are carefully packed, tightly secured and properly stored, ready to be delivered to our customers for potable water applications. Similar to the straight Bute-PE pipes, these coiled pipes are also in full compliance with MS1058.2:2002 and when properly joint with Bute-PE fittings, will provide a leak-free solution for the conveyance of clean healthy drinking water.

As at today, thousands of rolls of our coiled Bute-PE pipes have been shipped out from our factory to our customers all over Malaysia and soon you may see them lying on the floor in your nearby hardware stores.

Kudos to Buteline MY Team for reaching this new milestone!

Bute-PE pipes, each in 50-m coil, were being loaded into this 20-ft container together with other Buteline products.