The Buteline Plumbing System is designed to be used with complete confidence. You will get a simple, controlled, accurate joint every time. The flexibility of Buteline pipe also means easier installation in confined spaces. 

Below is a quick installation guide:

Step 1  Cut Buteline Pipe

Step 1: Cut Buteline pipe

Always use a Buteline pipe cutter to ensure a square, clean, burr free cut.
Cut the pipe on an indicator line.

To assist the pipe cutting process slightly twist the cutter as you begin to cut.

 

 

 

Step 2  Insert Pipe into Buteline Fitting

Step 2: Insert PB-1 pipe into Buteline fittingOnce you have cut the pipe, simply insert the pipe into the Buteline fitting and push fully home to the shoulder of the fitting (up to the next indicator line of the same size).

 

 

 

 

 

Step 3  Clamp Fitting

Step 3: Clamp fitting with Buteline Clamp Tool Clamp the Buteline fitting, using ONLY the Buteline clamp tool.

Position the Buteline clamp tool squarely, approximately 2mm in from the end of the clamp ring.

Close handles to stops, hold in the tightly closed position for a moment to ensure that the flow of material is performed. Open and remove the tool.

* When burying Buteline fittings underground or when in contact with concrete (or when using for marine purposes), wrap the aluminium rings directly with PVC insulation tape or similar to prevent corrosion.  

 

Step 4  All complete!

Step 4: All complete -- you have a strong, secure and watertight jointInstalling the Buteline Plumbing System is quick and sure and always provides a visual indicator of joint completion.

As you can see, the process of using the Buteline system is quick, simple and highly efficient.

 

 

Installation of the Recycled Water & Rainwater Systems is the same as for the standard PB-1 Buteline Plumbing System. Please refer to our Plumbers Technical & Installation Manual for more information.

 

Download the Buteline Product Wallchart